Channelux LED modules can be installed anywhere along the length of the handrail. They fit flush inside the channel, connect together in a ‘daisy chain’ and can be powered by low voltage wires via any wall connection or Sprocketlock bracket. The modules are suitable for indoor or outdoor use.
How many modules should I use?
Three modules have approximately the same light output as one 60W bulb. The brightest area below the module is about 4 feet wide. If you place modules every 3 feet (the same as brackets) you will get strong and even light. You can also use fewer modules for accent or spot lighting.
How are the modules powered?
Any 24VDC constant voltage driver (transformer) will work. Each module consumes 2W, so the driver must be sized appropriately. Up to 48 modules can be powered by one 100W driver. Small plug-in 24VDC power supplies are an inexpensive way to power smaller numbers of modules. Search online for ’24VDC power supply for LED strip lighting’ and you will find hundreds of options.
How are the modules controlled?
The simplest way to control Channelux LED modules is to power the driver on and off with a standard wall switch.
Dimmable LED drivers that can be controlled by a dimmer switch may also be used, but you must take care to insure that the driver is sized according to the total wattage of your installation (a driver that is oversized will not dim properly) and that the driver and dimmer switch are compatible.
You can also install a dimmer that is rated for strip lighting between a standard (non-dimmable) driver and the Channelux modules. These devices have their own remote controls and many are compatible with Google Home, Alexa, or Apple Home Kit. Search online for ‘dimmer for LED strip lighting’.
